State GTS-140-PIH User Manual download pdf (Page 25)

25 Page

Installaon

Installaon Manual

Follow the electrical code requirements of the local authority having jurisdiction.

In the absence of such requirements, follow the latest edition of the National

Electrical Code ANSI/NFPA 70 in the U.S. or the latest edition of CSA C22.1

Canadian Electrical Code Part 1 in Canada.

WARNING

When servicing or replacing parts within the water heater, label all wires prior to

disconnection to facilitate an easy and error-free reconnection. Wiring errors can

cause improper and dangerous operation. Verify proper operation after servicing.

CAUTION

• The condensate drain is at atmospheric pressure (non-pressurized) and

therefore must be allowed to drain freely with gravity only. Please ensure that

there are no blockages along the condensate drain tube. Allportionsofthe

condensatedrain(neutralizeranddraintube)mustbeata lowerelevation

thanthewaterheatertopreventcondensatewaterfrombuildingupinside

theheatexchanger.

• Condensate cannot be effectively neutralized if the neutralizer elements inside

the Neutralizer accessory have been completely consumed. If this happens,

condensate will remain acidic and can possibly cause damage to items such as

pipes, concrete, etc., if drained improperly.

• The Neutralizer cartridge is designed to last for 3 years before replacement.

However, the actual life of the neutralizer may vary, depending on the

application and usage. Please ensure that the cartridge is properly replaced

before the neutralizer elements have been completely consumed.

• All preventative measures and safety practices must be adhered to when

draining condensate. The manufacturer will not be responsible for any damage

caused by condensate.

• A drain pan, or other means of protection against water damage, is required to

be installed under the water heater in case of leaks.

WARNING

Outdoormodel

Boomviewofwaterheater

View of electrical

conneconsofwaterheater

Indoormodel

Connect

Powersupply

120VAC,60Hz

Ground

Greenscrew

ELECTRICAL CONNECTIONS

AllIndoormodelscomewithapowerpluginsteadofajunctionbox.Thefollowingprocedureisfor

theoutdoormodelonly.

1. The water heater must be electrically grounded. Do not attach the ground wire to either the gas or

the water piping.

2. The water heater requires 120VAC,60Hzelectricalpowersupplythatisproperlygrounded.

• A proper disconnect (i.e. on/off switch, power plug, etc.) controlling the main power to the water

heater must be provided for service reasons. (Must comply with local codes.)

• Connect the power supply to the water heater exactly as shown in the wiring diagram.

3. A green screw is provided in the junction box to ground the connection.

4. Can be hardwired or wired to a plug-in.

5. The use of a surge protector is recommended in order to protect the water heater from power surges.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 55 56

Comments to this Manuals

No comments

State GTS-140-PIH User Manual Page 25

Comments to this Manuals

Related products and manuals for Water boiler State GTS-140-PIH